Help! P1000 & P1309 Codes?!
#1
Help! P1000 & P1309 Codes?!
Hi! I'm Ken Tommy from Norway. I'm new at this forum.
My Ranger broke down while I was driving.
It wouldn't start again! But the day after it did.
And the problem started again after a few days.
Got it to a garage/shop and got the codes:
P1309 Misfire monitor mode disabled.
P1000 Powertrain Control Module ROM error.
The engine is running for now! The CEL light is not on.
I have driven it for maybe 2 hours after I reconnected the minus at the battery. It where off for about 10 Minutes
What do I have to do? I apriciate all the help I can get!
Sorry if the english is a little bad.
It's a Ranger 2.5 L4. 1998 model.
EEC-V ML2-712 8A24
F87F-12A660-SC G FLH2
(Numbers on PCM)
Thanks for all answers!
My Ranger broke down while I was driving.
It wouldn't start again! But the day after it did.
And the problem started again after a few days.
Got it to a garage/shop and got the codes:
P1309 Misfire monitor mode disabled.
P1000 Powertrain Control Module ROM error.
The engine is running for now! The CEL light is not on.
I have driven it for maybe 2 hours after I reconnected the minus at the battery. It where off for about 10 Minutes
What do I have to do? I apriciate all the help I can get!
Sorry if the english is a little bad.
It's a Ranger 2.5 L4. 1998 model.
EEC-V ML2-712 8A24
F87F-12A660-SC G FLH2
(Numbers on PCM)
Thanks for all answers!
#2
Thread
Thread Starter
Forum
Replies
Last Post