FR36S Skyjacker 6" Leaf Spring Bushing on 2009
Thread Starter
|
Member
Joined: Dec 2009
Posts: 65
Likes: 0
From: Toronto, ON
FR36S Skyjacker 6" Leaf Spring Bushing on 2009
Hey all,
So I'm in the middle of swapping out my stock rear leafs for the Skyjacker 6" FR36S and I've realized a lesser known fact about the swap. The front bolts on my '09 ranger are too large for the skyjacker bushing. I tried to swap the bushings out (a 6" gear puller does the trick for removing them if you put a bolt through the bushing to have something for the puller's screw to push against).
Anyway, the stock bushing is too large to fit the Skyjacker leaf eye so I think I need bushings. I don't want to use a smaller bolt; seems to me that would rattle and hammer unnecessarily.
Has anyone run into this issue? How did you resolve it? Is there a bushing out there that will do the trick (outer diameter of the leaf's eye but inner diameter of the stock bolt).
Thank you!
So I'm in the middle of swapping out my stock rear leafs for the Skyjacker 6" FR36S and I've realized a lesser known fact about the swap. The front bolts on my '09 ranger are too large for the skyjacker bushing. I tried to swap the bushings out (a 6" gear puller does the trick for removing them if you put a bolt through the bushing to have something for the puller's screw to push against).
Anyway, the stock bushing is too large to fit the Skyjacker leaf eye so I think I need bushings. I don't want to use a smaller bolt; seems to me that would rattle and hammer unnecessarily.
Has anyone run into this issue? How did you resolve it? Is there a bushing out there that will do the trick (outer diameter of the leaf's eye but inner diameter of the stock bolt).
Thank you!
Member
Joined: Oct 2019
Posts: 24
Likes: 0
From: Memphis,TN
Hey all,
So I'm in the middle of swapping out my stock rear leafs for the Skyjacker 6" FR36S and I've realized a lesser known fact about the swap. The front bolts on my '09 ranger are too large for the skyjacker bushing. I tried to swap the bushings out (a 6" gear puller does the trick for removing them if you put a bolt through the bushing to have something for the puller's screw to push against).
Anyway, the stock bushing is too large to fit the Skyjacker leaf eye so I think I need bushings. I don't want to use a smaller bolt; seems to me that would rattle and hammer unnecessarily.
Has anyone run into this issue? How did you resolve it? Is there a bushing out there that will do the trick (outer diameter of the leaf's eye but inner diameter of the stock bolt).
Thank you!
So I'm in the middle of swapping out my stock rear leafs for the Skyjacker 6" FR36S and I've realized a lesser known fact about the swap. The front bolts on my '09 ranger are too large for the skyjacker bushing. I tried to swap the bushings out (a 6" gear puller does the trick for removing them if you put a bolt through the bushing to have something for the puller's screw to push against).
Anyway, the stock bushing is too large to fit the Skyjacker leaf eye so I think I need bushings. I don't want to use a smaller bolt; seems to me that would rattle and hammer unnecessarily.
Has anyone run into this issue? How did you resolve it? Is there a bushing out there that will do the trick (outer diameter of the leaf's eye but inner diameter of the stock bolt).
Thank you!
did you ever figure this out?
Thread
Thread Starter
Forum
Replies
Last Post
NewShockerGuy
Suspension Tech
2
Jul 31, 2014 05:36 PM
