Dont like Rack and Pinion? Swap it out.
#1
Dont like Rack and Pinion? Swap it out.
http://www.explorerforum.com/forums/...d.php?t=181266
I thought some of you guys might find that thread interesting. Its being done on an Explorer, but the frames the same up front for the most part. He is actually the guy I sold my RCD lift to back when I took it off.
I thought some of you guys might find that thread interesting. Its being done on an Explorer, but the frames the same up front for the most part. He is actually the guy I sold my RCD lift to back when I took it off.
#2
Member
iTrader: (10)
Join Date: May 2006
Location: Boerne, TX
Posts: 1,997
Likes: 0
Received 0 Likes
on
0 Posts
reviving an old thread.....i think i might look into doing this. my rack is shot and this looks very feasible. plus it would make a sas go tons faster if this were done beforehand
however, i dont like how he put the steering box on the inside. i dont know how he got it to fit. AND he is putting a 5.0 in there. you think this would work by using a steering box that goes on the outside of the frame? maybe like a 2wd chevy ifs setup...
however, i dont like how he put the steering box on the inside. i dont know how he got it to fit. AND he is putting a 5.0 in there. you think this would work by using a steering box that goes on the outside of the frame? maybe like a 2wd chevy ifs setup...
Last edited by shadow905; 04-20-2009 at 03:03 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Lightning-Junior
8-Cylinder Tech
3
11-30-2013 12:00 AM