upper ball joint help!!!!!!
#1
upper ball joint help!!!!!!
alright so my balljoint project is at a stop i took the nut off the nuckle which looks like it kept it tight, the bolt wont come out though..idk if it's suposed to or not,but i cant get the upper ball joint separated from the nuckle i'm using a pickle fork and a bfh
i need some help
i need some help
#5
do not jack the truck up by the lower control arm, lift it by the frame or center cross member so the suspension hangs relaxed. that bolt has to come out before the ball joint stud will pop out of the knuckle. PB blast or some heat with a torch assisted by a hammer should get that bolt out. plan on replacing that bolt when youre done. some replacement balljoints/ upper control arms come with them anyways.
#7
Thread
Thread Starter
Forum
Replies
Last Post