Had my drivers seat cut down to a bucket seat, installed my expo center console, painted exposed parts of my frame in the rear wheel wells, also painted exhaust and trailer hitch.

 

I finally installed my 4.10 limited slip rear end

 

blew the leaves and ish off it and mowed the lawn next to where its parked

 

drove it up to the mountain were i am working on mountain bike trails, drove it to a couple parts yards in an attempt ot find my d2 axle.

 

thought about boring out block and getting bigger pistons, different vavles, cam etc. etc.

 

hooked up my box trailer and helped a freind move.

 

Finished swapping my leaf springs and replaced all the shocks. The rear after all the work done to it has lifted 2" (from 20" to 22" between wheel hub and bottom of flare) and the front lifted 1" (19" to 20"). Now when I get time I am going to crank the t-bars and level the front with the back.

 

ordered an ipod cable for my alpine deck

 

Cleaned the K&N, MAF, and the other sensor by the throttle body.

 

Changed the oil in the Ranger for the first time. Valvoline full synthetic.

Also cleaned the Ranger and the Bronco

 

Dwarf, you better do full syn oil changes for the rest of your life.

 

AVS window visors

 

LED reverse lights, new LED maplights

 

Well ive had it a week, but today I tried to fix the horns(need new ones). Did more research on ac fade out by pcm (need to find a way to bypass that) and searching for accessories like a bed cover, foglight lower valance? from explorer(seen that somewhere) compass console swap etc etc etc

 

I wanna do that, but have red, and white, switchable.

 

Bought my truck a canopy, gave the canopy its first coat of black paint to match the truck, and i painted my rims. This is what happens when i don't go camping because my boss has me work ot, now i hope it happens more because there are a few more things i'd like to get/do to the truck.

 

Replaced the starter got tired of push starting!

 

new oil and filter. Next up front and rear pinion seals.

 

Washed her and a couple of hours later it rained... pfff

 

rotated my tires.

 

bought some clear corners..well yesterday. Is there a how-to for modding these? (pulling them apart and blacking out the inside) i searched and couldnt find.

 

Just bake them like the headlight mod

 

got the grease stains out of the seats and got the touch up spots done and tomorrow will be ....... idk scratch removal?

 

went searching for mustang brakes.... found a full set but couldnt pull because they dont want to part with them...bitc*'s

 

6-14-10: Removed the bed with fuel cell, narrowed the rearend 3", pulled the axles to put in NEW axle & pinion seals...........
================================================== ====
UPDATE 6-16-10: NEW axle & pinion seals installed, and rearend all buttoned up.