just a little project for the ranger
It drives right now. Its not registered though haha but as i said before, i gain interest, lose interest, gain interest, lose interest, but at the moment i am gathering parts for a f250 brake master cylinder swap cause the stock ranger brakes are inadequate for the tons.
Didn't pass smog. The emission's test was a pass, but the function check failed. "This vehicle did not pass the OBD system check because its OBD system was not ready to test"
Need to get some drive cycles under its belt before a re-test. So far i have about 30 miles on it just today. Got it up to 55 and there is a slight shake in the wheel, but it needs an alignment. Currently just used a tape to get it close as possible.
Need to get some drive cycles under its belt before a re-test. So far i have about 30 miles on it just today. Got it up to 55 and there is a slight shake in the wheel, but it needs an alignment. Currently just used a tape to get it close as possible.
Thread
Thread Starter
Forum
Replies
Last Post









haha just kidding. 