SAS Front Axle ?
#26
In the next couple weeks I'm going to work on picking up my axles but going to take a little searching lol.
#27
#28
Ok thats cool I'll have to compare prices with local machine shops too. And I will also have to keep that in mind because I am trying to keep the width of both axles similiar. So prob my best bet is to get the knuckles and everything to run high steer set up then see how much to shorten it lol
#30
No, studs are separate. Here's the link for you:
1-AMDT - machine, drill and tap your D44 flat top knuckle LABOR ONLY
1-AMDT - machine, drill and tap your D44 flat top knuckle LABOR ONLY
#33
I'll keep the thread going as I gather parts....just been buying tools slowly as well so funds start to get low. Should be building a new front bumper here soon to better protect my radiator and what not. Also going to plate the bottom of my lower control arms to beef them up and help me slide off rocks instead of getting hung up. Obv it is only temporary so I can still wheel until axles are built and ready to drop in. Will post pics as I move along.
Thanks again
Thanks again
Thread
Thread Starter
Forum
Replies
Last Post