SOHC - 2.3L & 2.5L Lima Engines Discussions and Topics specific to the Lima 4 cylinder engines

alot of oil in tthe intake tube

Thread Tools
 
Search this Thread
 
  #1  
Old 04-27-2010
fearfact's Avatar
Member
Thread Starter
Join Date: Mar 2010
Location: winchester, ca
Posts: 10
Likes: 0
Received 0 Likes on 0 Posts
alot of oil in tthe intake tube

another question about my POS 95 2.3L! in the last 2 or 3 weeks i have had the check eng light 2 times, each time i have puuled the air tube off and had to drain oil from the piece between the cover vent tube and the throttle body. commonly i see oil on the engine side of that vent tube aswell, its obvious that its from there.. why would SO much oil come from it...probably about 1/4 quart over 2-250 miles, occasionally itll bog down and smoke but ha only happened 2 times total, other than that its just a typical underpowered turd!..thanks
 
  #2  
Old 04-27-2010
OTRtech's Avatar
Member
Join Date: Mar 2007
Location: Upstate,NY
Posts: 2,598
Likes: 0
Received 11 Likes on 11 Posts
Change the PCV valve . It may be sticking closed and allowing too much pressure buildup and allowing oil to pass by to the intake.
Also the drain-back oil passages from the head to the crankcase may be full of sludge and not letting the oil go down where it needs to.
 
  #3  
Old 04-28-2010
cheese_man's Avatar
Member
iTrader: (1)
Join Date: Nov 2009
Location: arthur
Posts: 2,126
Likes: 0
Received 4 Likes on 4 Posts
use some spray brake cleaner
spray inside the little pcv valve hole and shake it for several minutes

keep doing it until the check ball rattles freely
( until you can purchase a new 1 )
 
  #4  
Old 04-28-2010
fearfact's Avatar
Member
Thread Starter
Join Date: Mar 2010
Location: winchester, ca
Posts: 10
Likes: 0
Received 0 Likes on 0 Posts
where th ehell is this valve! haynes manual says its by the oil collector ( left side of eng) problem is i dont know where that is! any pics out there to walk me on? thanks again guys
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
06FordFX4
Fabrication & Tool Tech
6
04-23-2012 04:35 PM
Col.Mustard
2.9L & 3.0L V6 Tech
4
11-26-2010 09:24 AM
04_xlt_4.0_4x4
4.0L OHV & SOHC V6 Tech
18
08-16-2010 07:48 PM
03 DEMON 4X4 SOHC
4.0L OHV & SOHC V6 Tech
0
05-15-2010 03:45 PM
93MVSplash
Snapshots
24
04-18-2009 09:51 PM



Quick Reply: alot of oil in tthe intake tube



All times are GMT -6. The time now is 10:08 PM.